| 1 | /*- |
| 2 | * SPDX-License-Identifier: BSD-3-Clause |
| 3 | * |
| 4 | * Copyright (c) 1991 The Regents of the University of California. |
| 5 | * All rights reserved. |
| 6 | * |
| 7 | * Redistribution and use in source and binary forms, with or without |
| 8 | * modification, are permitted provided that the following conditions |
| 9 | * are met: |
| 10 | * 1. Redistributions of source code must retain the above copyright |
| 11 | * notice, this list of conditions and the following disclaimer. |
| 12 | * 2. Redistributions in binary form must reproduce the above copyright |
| 13 | * notice, this list of conditions and the following disclaimer in the |
| 14 | * documentation and/or other materials provided with the distribution. |
| 15 | * 3. Neither the name of the University nor the names of its contributors |
| 16 | * may be used to endorse or promote products derived from this software |
| 17 | * without specific prior written permission. |
| 18 | * |
| 19 | * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND |
| 20 | * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE |
| 21 | * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE |
| 22 | * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE |
| 23 | * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL |
| 24 | * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS |
| 25 | * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) |
| 26 | * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT |
| 27 | * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY |
| 28 | * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF |
| 29 | * SUCH DAMAGE. |
| 30 | */ |
| 31 | |
| 32 | /* |
| 33 | * Nec 765 floppy disc controller definitions |
| 34 | */ |
| 35 | |
| 36 | /* Main status register */ |
| 37 | #define NE7_DAB		0x01	/* Diskette drive A is seeking, thus busy */ |
| 38 | #define NE7_DBB		0x02	/* Diskette drive B is seeking, thus busy */ |
| 39 | #define NE7_CB		0x10	/* Diskette Controller Busy */ |
| 40 | #define NE7_NDM		0x20	/* Diskette Controller in Non Dma Mode */ |
| 41 | #define NE7_DIO		0x40	/* Diskette Controller Data register I/O */ |
| 42 | #define NE7_RQM		0x80	/* Diskette Controller ReQuest for Master */ |
| 43 | |
| 44 | /* Status register ST0 */ |
| 45 | #define NE7_ST0BITS	"\020\010invld\007abnrml\006seek_cmplt\005equ_chck\004drive_notrdy\003top_head" |
| 46 | |
| 47 | #define NE7_ST0_IC	0xc0	/* interrupt completion code */ |
| 48 | |
| 49 | #define NE7_ST0_IC_RC	0xc0	/* terminated due to ready changed, n/a */ |
| 50 | #define NE7_ST0_IC_IV	0x80	/* invalid command; must reset FDC */ |
| 51 | #define NE7_ST0_IC_AT	0x40	/* abnormal termination, check error stat */ |
| 52 | #define NE7_ST0_IC_NT	0x00	/* normal termination */ |
| 53 | |
| 54 | #define NE7_ST0_SE	0x20	/* seek end */ |
| 55 | #define NE7_ST0_EC	0x10	/* equipment check, recalibrated but no trk0 */ |
| 56 | #define NE7_ST0_NR	0x08	/* not ready (n/a) */ |
| 57 | #define NE7_ST0_HD	0x04	/* upper head selected */ |
| 58 | #define NE7_ST0_DR	0x03	/* drive code */ |
| 59 | |
| 60 | /* Status register ST1 */ |
| 61 | #define NE7_ST1BITS	"\020\010end_of_cyl\006bad_crc\005data_overrun\003sec_not_fnd\002write_protect\001no_am" |
| 62 | |
| 63 | #define NE7_ST1_EN	0x80	/* end of cylinder, access past last record */ |
| 64 | #define NE7_ST1_DE	0x20	/* data error, CRC fail in ID or data */ |
| 65 | #define NE7_ST1_OR	0x10	/* DMA overrun, DMA failed to do i/o quickly */ |
| 66 | #define NE7_ST1_ND	0x04	/* no data, sector not found or CRC in ID f. */ |
| 67 | #define NE7_ST1_NW	0x02	/* not writeable, attempt to violate WP */ |
| 68 | #define NE7_ST1_MA	0x01	/* missing address mark (in ID or data field)*/ |
| 69 | |
| 70 | /* Status register ST2 */ |
| 71 | #define NE7_ST2BITS	"\020\007ctrl_mrk\006bad_crc\005wrong_cyl\004scn_eq\003scn_not_fnd\002bad_cyl\001no_dam" |
| 72 | |
| 73 | #define NE7_ST2_CM	0x40	/* control mark; found deleted data */ |
| 74 | #define NE7_ST2_DD	0x20	/* data error in data field, CRC fail */ |
| 75 | #define NE7_ST2_WC	0x10	/* wrong cylinder, ID field mismatches cmd */ |
| 76 | #define NE7_ST2_SH	0x08	/* scan equal hit */ |
| 77 | #define NE7_ST2_SN	0x04	/* scan not satisfied */ |
| 78 | #define NE7_ST2_BC	0x02	/* bad cylinder, cylinder marked 0xff */ |
| 79 | #define NE7_ST2_MD	0x01	/* missing address mark in data field */ |
| 80 | |
| 81 | /* Status register ST3 */ |
| 82 | #define NE7_ST3BITS	"\020\010fault\007write_protect\006drdy\005tk0\004two_side\003side_sel\002" |
| 83 | |
| 84 | #define NE7_ST3_FT	0x80	/* fault; PC: n/a */ |
| 85 | #define NE7_ST3_WP	0x40	/* write protected */ |
| 86 | #define NE7_ST3_RD	0x20	/* ready; PC: always true */ |
| 87 | #define NE7_ST3_T0	0x10	/* track 0 */ |
| 88 | #define NE7_ST3_TS	0x08	/* two-sided; PC: n/a */ |
| 89 | #define NE7_ST3_HD	0x04	/* upper head select */ |
| 90 | #define NE7_ST3_US	0x03	/* unit select */ |
| 91 | |
| 92 | /* Data Rate Select Register DSR (enhanced controller) */ |
| 93 | #define I8207X_DSR_SR	0x80	/* software reset */ |
| 94 | #define I8207X_DSR_LP	0x40	/* low power */ |
| 95 | #define I8207X_DSR_PS	0x1c	/* precompensation select */ |
| 96 | #define I8207X_DSR_RS	0x03	/* data rate select */ |
| 97 | |
| 98 | /* Commands */ |
| 99 | /* |
| 100 | * the top three bits -- where appropriate -- are set as follows: |
| 101 | * |
| 102 | * MT - multi-track; allow both sides to be handled in single cmd |
| 103 | * MFM - modified frequency modulation; use MFM encoding |
| 104 | * SK - skip; skip sectors marked as "deleted" |
| 105 | */ |
| 106 | |
| 107 | #define NE7CMD_MT	0x80	/* READ, WRITE, WRITEDEL, READDEL, SCAN* */ |
| 108 | #define NE7CMD_MFM	0x40	/* same as MT, plus READTRK, READID, FORMAT */ |
| 109 | #define NE7CMD_SK	0x20	/* READ, READDEL, SCAN* */ |
| 110 | |
| 111 | #define NE7CMD_READTRK	0x02	/* read whole track */ |
| 112 | #define NE7CMD_SPECIFY	0x03	/* specify drive parameters - requires unit |
| 113 | 				 * parameters byte */ |
| 114 | #define NE7CMD_SENSED	0x04	/* sense drive - requires unit select byte */ |
| 115 | #define NE7CMD_WRITE	0x05	/* write - requires eight additional bytes */ |
| 116 | #define NE7CMD_READ	0x06	/* read - requires eight additional bytes */ |
| 117 | #define NE7CMD_RECAL	0x07	/* recalibrate drive - requires |
| 118 | 				 * unit select byte */ |
| 119 | #define NE7CMD_SENSEI	0x08	/* sense controller interrupt status */ |
| 120 | #define NE7CMD_WRITEDEL	0x09	/* write deleted data */ |
| 121 | #define NE7CMD_READID	0x0a	/* read ID field */ |
| 122 | #define NE7CMD_READDEL	0x0c	/* read deleted data */ |
| 123 | #define NE7CMD_FORMAT	0x0d	/* format - requires five additional bytes */ |
| 124 | #define NE7CMD_SEEK	0x0f	/* seek drive - requires unit select byte |
| 125 | 				 * and new cyl byte */ |
| 126 | #define NE7CMD_VERSION	0x10	/* get version */ |
| 127 | #define NE7CMD_SCNEQU	0x11	/* scan equal */ |
| 128 | #define NE7CMD_SCNLE	0x19	/* scan less or equal */ |
| 129 | #define NE7CMD_SCNGE	0x1d	/* scan greater or equal */ |
| 130 | |
| 131 | /* |
| 132 | * Enhanced controller commands: |
| 133 | */ |
| 134 | #define I8207X_DUMPREG	0x0e	/* dump internal registers */ |
| 135 | #define I8207X_CONFIG	0x13	/* configure enhanced features */ |
| 136 | |
| 137 | /* |
| 138 | * "specify" definitions |
| 139 | * |
| 140 | * acronyms (times are relative to a FDC clock of 8 MHz): |
| 141 | * srt - step rate; PC usually 3 ms |
| 142 | * hut - head unload time; PC usually maximum of 240 ms |
| 143 | * hlt - head load time; PC usually minimum of 2 ms |
| 144 | * nd - no DMA flag; PC usually not set (0) |
| 145 | */ |
| 146 | |
| 147 | #define NE7_SPEC_1(srt, hut)	(((16 - (srt)) << 4) | (((hut) / 16))) |
| 148 | #define NE7_SPEC_2(hlt, nd)	(((hlt) & 0xFE) | ((nd) & 1)) |